Calibration of a lactic-acid model for simulating biofilm-induced degradation of the dentin-composite interface

Publication date: Available online 8 September 2017
Source:Dental Materials
Author(s): Laikuan Zhu, Yuping Li, Carola A. Carrera, Yung-Chung Chen, Mingyu Li, Alex Fok
ObjectiveTo verify and calibrate a chemical model for simulating the degradation of the dentin-composite interface induced by multi-species oral biofilms in vitro.MethodsDentin-composite disks (5-mm dia.×2-mm thick) were made from bovine incisor roots and filled with either Z100™ (Z100) or Filtek™ LS (LS) composite. The disks, which were covered with nail varnish, but with one of the dentin-composite margins exposed, were immersed in lactic acid solution at pH 4.5 for up to 48h. Diametral compression was performed to measure the reduction in bond strength of the dentin-composite disks following acid challenge. Scanning electron microscopy (SEM) was used to examine decalcification of dentin and fracture modes of the disks. To better understand the degradation process, micro-computed tomography, in combination with a radiopaque dye (AgNO3), was used to assess interfacial leakage in 3D longitudinally, while SEM was used to determine the path of leakage. One-way analysis of variance (ANOVA) was used to analyze the results, with the level of statistical significance set at p<0.05. The results were compared with those obtained previously using multi-species biofilms for verification and calibration purposes.ResultsAfter 48h of acid challenge, the debonding load of both the LS- and Z100-filled disks reduced significantly (p<0.05). In the Z100-filled disks, debonding mostly occurred at the adhesive-dentin interface, while in the LS-filled disks, this happened at the adhesive-composite interface, instead. The degree of dentin demineralization, the reduction in debonding load and the modes of failure observed were very similar to those induced by multi-species oral biofilms found in the previous work. Leakage of AgNO3 occurred mainly along the hybrid layer. The specimens filled with Z100 had a thicker hybrid layer (∼6.5μm), which exhibited more interfacial leakage than those filled with LS.SignificanceThe chemical model with lactic acid used in this study can induce degradation to the dentin-composite interface similar to those produced by multi-species biofilms. With appropriate calibration, this could provide an effective in vitro method for ageing composite restorations in assessing their potential clinical performance.



from #ORL-AlexandrosSfakianakis via ola Kala on Inoreader http://ift.tt/2wP5fLw